G–Garbage-collect The route is in Garbage-collect state.
Peer Neighbor connected to the interface.
Destination IPv6 destination address.
via Next hop IPv6 address.
cost Routing metric value.
tag Route tag.
secs Time a route entry has stayed in the current state.
filter-policy export
Use filter-policy export to configure RIPng to filter redistributed routes. Only routes not filtered can be
advertised in update messages.
Use undo filter-policy export to remove the configuration.
Syntax
filter-policy { acl6-number | prefix-list prefix-list-name } export [ protocol [ process-id ] ]
undo filter-policy export [ protocol [ process-id ] ]
Default
RIPng does not filter redistributed routes.
Views
RIPng view
Predefined user roles
network-admin
Parameters
acl-number: Specifies an ACL by its number in the range of 2000 to 3999 to filter redistributed routes.
prefix-list prefix-list-name: Specifies an IPv6 prefix list by its name, a string of 1 to 63 characters, to filter
redistributed routes.
protocol: Filters routes redistributed from a routing protocol, including bgp4+, direct, isisv6, ospfv3,
ripng, and static.
process-id: Specifies the process ID of the specified routing protocol, in the range of 1 to 65535. This
argument is available only when the routing protocol is ripng, ospfv3, or isisv6. The default is 1.
Usage guidelines
If the protocol argument is specified, RIPng filters only redistributed routes redistributed from the specified
routing protocol. Otherwise, RIPng filters all redistributed routes.
To use an advanced ACL (with a number from 3000 to 3999) in the command, configure the ACL in one
of the following ways:
• To deny/permit a route with the specified destination, use the rule [ rule-id ] { deny | permit } ipv6
source sour sour-prefix command.
To Next Page
Loading...
