367
-------------------------------------------------------------------------
E1 - Type 1 external route, IA - Inter area route, I - Intra area route
E2 - Type 2 external route, * - Selected route
*Destination: 1001::/64
Type : I Cost : 1
NextHop : Direct Interface: Vlan12
Total: 1
Intra area: 1 Inter area: 0 ASE: 0
Table 88 Command output
Field Descri
Destination Destination network segment.
Type Route type.
Cost Route cost value.
NextHop Next hop address.
Interface Output interface.
Total Total number of routes.
Intra Area Number of intra-area routes.
Inter Area Number of inter-area routes.
ASE Number of external routes.
display ospfv3 statistics
Use display ospfv3 statistics to display OSPFv3 statistics.
Syntax
display ospfv3 [ process-id ] statistics
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
process-id: Specifies an OSPFv3 process by its ID in the range of 1 to 65535.
Usage guidelines
If no process is specified, this command displays OSPFv3 statistics for all processes.
Examples
# Display OSPFv3 statistics.
<Sysname> display ospfv3 statistics
To Next Page
Loading...
