429
Syntax
if-match community { { basic-community-list-number | name comm-list-name } [ whole-match ] |
adv-community-list-number }&<1-32>
undo if-match community [ { basic-community-list-number | name comm-list-name } [ whole-match ] |
adv-community-list-number ]&<1-32>
Default
No community list match criterion is configured.
Views
Routing policy node view
Predefined user roles
network-admin
Parameters
basic-community-list-number: Specifies a basic community list by its number in the range of 1 to 99.
adv-community-list-number: Specifies an advanced community list by its number in the range of 100 to
199.
comm-list-name: Specifies a community list by its name, a case-sensitive string of 1 to 63 characters that
cannot comprise only numbers.
whole-match: Exactly matches the specified community list.
&<1-32>: Indicates that the argument before it can be entered up to 32 times.
Examples
# Configure community list 1 to permit BGP routes with community number 100 or 200. Then configure
node 10 in permit mode for routing policy test to use community list 1 to match BGP routes.
<Sysname> system-view
[Sysname] ip community-list 1 permit 100 200
[Sysname] route-policy test permit node 10
[Sysname-route-policy-test-10] if-match community 1
Related commands
• apply community
• ip community-list
if-match cost
Use if-match cost to match routing information having the specified cost.
Use undo if-match cost to restore the default.
Syntax
if-match cost value
undo if-match cost
Default
No cost match criterion is configured.
To Next Page
Loading...
