HP 6125XLG - Reset Ip Prefix-List; Ipv6 Routing Policy Configuration Commands; Apply Ipv6 Next-Hop

442
If both ip-address and mask-length are specified as 0.0.0.0 0, only the default route will be matched.
To match all routes, use 0.0.0.0 0 less-equal 32.
Examples
# Configure IP prefix list p1 to permit routes destined for network 10.0.0.0/8 and with mask length 17
or 18.
<Sysname> system-view
[Sysname] ip prefix-list p1 permit 10.0.0.0 8 greater-equal 17 less-equal 18
Related commands
• display ip prefix-list
• reset ip prefix-list
reset ip prefix-list
Use reset ip prefix-list to clear IPv4 prefix list statistics.
Syntax
reset ip prefix-list [ prefix-list-name ]
Views
User view
Predefined user roles
network-admin
Parameters
prefix-list-name: Specifies an IP prefix list by its name, a case-sensitive string of 1 to 63 characters.
Without this argument, this command clears statistics for all IPv4 prefix lists.
Examples
# Clear the statistics for IPv4 prefix list abc.
<Sysname> reset ip prefix-list abc
Related commands
• display ip prefix-list
• ip prefix-list
IPv6 routing policy configuration commands
apply ipv6 next-hop
Use apply ipv6 next-hop to set a next hop for IPv6 routes.
Use undo apply ipv6 next-hop to restore the default.
Syntax
apply ipv6 next-hop ipv6-address
undo apply ipv6 next-hop