HP 6125XLG - Output-Delay; Preference

45
[Sysname] rip 100
[Sysname-rip-100] network 129.102.0.0
output-delay
Use output-delay to configure the rate at which an interface sends RIP packets.
Use undo output-delay to restore the default.
Syntax
output-delay time count count
undo output-delay
Default
An interface sends up to three RIP packets every 20 milliseconds.
Views
RIP view
Predefined user roles
network-admin
Parameters
time: Specifies the sending interval in the range of 10 to 100 milliseconds.
count: Specifies the maximum number of RIP packets sent at each interval, in the range of 1 to 30.
Examples
# Configure all interfaces running RIP process 1 to send up to 10 RIP packets every 60 milliseconds.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] output-delay 60 count 10
preference
Use preference to specify a preference for RIP routes.
Use undo preference to restore the default.
Syntax
preference [ route-policy route-policy-name ] value
undo preference
Default
The preference of RIP routes is 100.
Views
RIP view
Predefined user roles
network-admin