11
Summary Count : 0
# Display brief information about static routes.
<Sysname> display ip routing-table protocol static
Summary Count : 2
Static Routing Table Status : <Active>
Summary Count : 0
Static Routing Table Status : <Inactive>
Summary Count : 2
Destination/Mask Proto Pre Cost NextHop Interface
1.2.3.0/24 Static 60 0 1.2.4.5 Vlan10
3.0.0.0/8 Static 60 0 2.2.2.2 Vlan21
For command output, see Table 1.
display ip routing-table statistics
Use display ip routing-table statistics to display IPv4 route statistics.
Syntax
display ip routing-table [ vpn-instance vpn-instance-name ] statistics
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters. Without this option, the command displays route statistics for the public network.
Examples
# Display IPv4 route statistics for the public network.
<Sysname> display ip routing-table statistics
Proto route active added deleted
DIRECT 12 12 30 18
STATIC 3 3 5 2
RIP 0 0 0 0
OSPF 0 0 0 0
ISIS 0 0 0 0
BGP 0 0 0 0
Total 15 15 35 20
To Next Page
Loading...
