383
ospfv3 mtu-ignore
Use ospfv3 mtu-ignore to configure an interface to ignore MTU check during DD packet exchange.
Use undo ospfv3 mtu-ignore to restore the default.
Syntax
ospfv3 mtu-ignore [ instance instance-id ]
undo ospfv3 mtu-ignore [ instance instance-id ]
Default
An interface performs MTU check during DD packet exchange.
Views
Interface view
Predefined user roles
network-admin
Parameters
instance-id: Specifies an instance by its ID in the range of 0 to 255. The default is 0.
Usage guidelines
A neighbor relationship can be established only if the interface's MTU is the same as that of the peer.
Examples
# Configure VLAN-interface 10 that belongs to instance 1 to ignore MTU check during DD packet
exchange.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 mtu-ignore instance 1
ospfv3 network-type
Use ospfv3 network-type to set the network type for an OSPFv3 interface.
Use undo ospfv3 network-type to restore the default.
Syntax
ospfv3 network-type { broadcast | nbma | p2mp [ unicast ] | p2p } [ instance instance-id ]
undo ospfv3 network-type [ instance instance-id ]
Default
The network type of an OSPFv3 interface depends on its link layer protocol:
• For Ethernet and FDDI, the default network type is broadcast.
• For ATM, FR, and X.25, the default network type is NBMA.
• For PPP, LAPB, HDLC, and POS, the default network type is P2P.
Views
Interface view
To Next Page
Loading...
