HP 6125XLG - Apply Preferred-Value

423
Views
Routing policy node view
Predefined user roles
network-admin
Parameters
preference: Specifies a preference in the range of 1 to 255.
Usage guidelines
If you have set preferences for routing protocols with the preference command, the apply preference
command sets a new preference for the matching routing protocol. Non-matching routing protocols still
use the preferences set by the preference command.
Examples
# Configure node 10 in permit mode for routing policy policy1 to set the preference for OSPF external
routes to 90.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy-policy1-10] if-match route-type external-type1or2
[Sysname-route-policy-policy1-10] apply preference 90
apply preferred-value
Use apply preferred-value to set a preferred value for BGP routes.
Use undo apply preferred-value to restore the default.
Syntax
apply preferred-value preferred-value
undo apply preferred-value
Default
No preferred value is set for BGP routes.
Views
Routing policy node view
Predefined user roles
network-admin
Parameters
preferred-value: Specifies a preferred value in the range of 0 to 65535.
Examples
# Configure node 10 in permit mode for routing policy policy1 to set a preferred value of 66 for BGP
routes matching AS path list 1.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy-policy1-10] if-match as-path 1
[Sysname-route-policy-policy1-10] apply preferred-value 66