350
Syntax
area area-id
undo area area-id
Default
No OSPFv3 area is created.
Views
OSPFv3 view
Predefined user roles
network-admin
Parameters
area-id: Specifies an area by its ID, an IPv4 address or a decimal integer in the range of 0 to
4294967295 that is changed to an IPv4 address by the system.
Examples
# Create OSPFv3 area 0 and enter its view.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] area 0
[Sysname-ospfv3-1-area-0.0.0.0]
bandwidth-reference
Use bandwidth-reference to specify a reference bandwidth value for link cost calculation.
Use undo bandwidth-reference to restore the default.
Syntax
bandwidth-reference value
undo bandwidth-reference
Default
The default value is 100 Mbps.
Views
OSPFv3 view
Predefined user roles
network-admin
Parameters
value: Specifies the bandwidth reference value for link cost calculation, in the range of 1 to 2147483648
Mbps.
Usage guidelines
You can configure an OSPFv3 cost for an interface with one of the following methods:
• Configure the cost value in interface view.
To Next Page
Loading...
