92
Parameters
process-id: Specifies an OSPF process by its ID in the range of 1 to 65535.
Usage guidelines
If no OSPF process is specified, this command displays the OSPF virtual link information for all OSPF
processes.
Examples
# Display OSPF virtual link information.
<Sysname> display ospf vlink
OSPF Process 1 with Router ID 3.3.3.3
Virtual Links
Virtual-link Neighbor-ID -> 2.2.2.2, Neighbor-State: Full
Interface: 10.1.2.1 (Vlan-interface11)
Cost: 1562 State: P-2-P Type: Virtual
Transit Area: 0.0.0.1
Timers: Hello 10 , Dead 40 , Retransmit 5 , Transmit Delay 1
Table 30 Command output
Field Descri
Virtual-link Neighbor-ID ID of the neighbor on the virtual link.
Neighbor-State Neighbor state: Down, Init, 2-Way, ExStart, Exchange, Loading, Full.
Interface IP address and name of the local interface on the virtual link.
Cost Interface route cost.
State Interface state.
Type Virtual link.
Transit Area Transit area ID.
Timers Values of timers: hello, dead, retransmit, and interface transmission delay.
display router id
Use display router id to display the global router ID.
Syntax
display router id
Views
Any view
Predefined user roles
network-admin
network-operator
Examples
# Display the global router ID.
To Next Page
Loading...
