189
Predefined user roles
network-admin
Parameters
system-id: Specifies an IS-IS neighbor by its system ID.
process-id: Specifies an IS-IS process by its ID in the range of 1 to 65535 to clear data structure
information for the neighbor in the specified IS-IS process.
Usage guidelines
Use this command when you re-establish an IS-IS neighbor relationship.
Examples
# Clear the data structure information of the neighbor with the system ID 0000.0c11.1111.
<Sysname> reset isis peer 0000.0c11.1111
set-overload
Use set-overload to set the overload bit.
Use undo set-overload to clear the overload bit.
Syntax
set-overload [ on-startup [ [ start-from-nbr system-id [ timeout1 [ nbr-timeout ] ] ] | timeout2 ] [ allow
{ external | interlevel } * ]
undo set-overload
Default
The overload bit is not set.
Views
IS-IS view
Predefined user roles
network-admin
Parameters
on-startup: Sets the overload bit upon system startup.
start-from-nbr system-id [ timeout1 [ nbr-timeout ] ]: Starts the nbr-timeout timer when the router begins
to establish the neighbor relationship with the neighbor after system startup. If the neighbor relationship
is formed within the nbr-timeout interval, IS-IS keeps the overload bit set. If not, the bit is cleared. IS-IS
keeps the overload bit set within the timeout1 interval after the neighbor relationship is formed within the
nbr-timeout interval.
• system-id—Specifies the neighbor.
• timeout1—The timeout1 interval is in the range of 5 to 86400 seconds and defaults to 600
seconds.
• nbr-timeout—The timer has an interval from 5 to 86400 seconds. The default is 1200 seconds.
timeout2: Sets the overload bit within the timeout2 interval after system startup. The interval is in the
range of 5 to 86400 seconds and defaults to 600 seconds.
To Next Page
Loading...
