262
[Sysname] bgp 100
[Sysname-bgp] ip vpn-instance vpn1
[Sysname-bgp-vpn1] ipv6-family unicast
[Sysname-bgp-ipv6-vpn1]
log-peer-change
Use log-peer-change to enable the logging of session state changes globally.
Use undo log-peer-change to disable the function.
Syntax
log-peer-change
undo log-peer-change
Default
Logging of session state changes is enabled globally.
Views
BGP view
Predefined user roles
network-admin
Usage guidelines
After you execute the log-peer-change command, BGP logs session establishment and disconnection
events. To view the log information, use the display bgp ipv4 peer log-info command.
If you disable the logging of session state changes globally, the display bgp ipv4 peer log-info command
does not show relevant log information.
Examples
# Enable the logging of session state changes globally.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] log-peer-change
Related commands
display bgp peer ipv4 unicast
network
Use network to inject a network to the BGP routing table.
Use undo network to remove the configuration.
Syntax
In BGP IPv4 unicast instance view/BGP-VPN IPv4 unicast instance view:
network ip-address [ mask | mask-length ] [ route-policy route-policy-name ]
undo network ip-address [ mask | mask-length ]
In BGP IPv6 unicast instance view/BGP-VPN IPv6 unicast instance view:
To Next Page
Loading...
