394
IPv6 IS-IS configuration commands
IPv6 IS-IS supports all the features of IPv4 IS-IS except that it advertises IPv6 routing information. This
chapter describes only IPv6 IS-IS exclusive commands. For other IS-IS configuration commands, see
"IS-IS configuration commands."
display isis redistribute ipv6
Use display isis redistribute ipv6 to display information about redistributed IPv6 IS-IS routes.
Syntax
display isis redistribute ipv6 [ ipv6-address mask-length ] [ level-1 | level-2 ] [ process-id ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
ipv6-address mask-length: Displays redistributed routes for the specified IPv6 address and mask length.
process-id: Displays redistributed routes for the IS-IS process specified by its ID in the range of 1 to
65535.
level-1: Displays IPv6 IS-IS Level-1 route information.
level-2: Displays IPv6 IS-IS Level-2 route information.
Usage guidelines
If no IPv6 IS-IS level is specified, this command displays both Level-1 and Level-2 route information.
Examples
# Display information about redistributed IPv6 IS-IS routes.
<Sysname> display isis redistribute ipv6 1
Route information for IS-IS(1)
------------------------------
Level-1 IPv6 Redistribute Table
--------------------------------
Type : direct Destination: 12:1::/64
IntCost : 0 Tag :
State : Active
Level-2 IPv6 Redistribute Table
--------------------------------
To Next Page
Loading...
