430
Views
Routing policy node view
Predefined user roles
network-admin
Parameters
value: Specifies a cost in the range of 0 to 4294967295.
Examples
# Configure node 10 in permit mode for routing policy policy1 to permit routing information with a cost
of 8.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy-policy1-10] if-match cost 8
if-match extcommunity
Use if-match extcommunity to match BGP routes whose extended community attribute matches a
specified extended community list.
Use undo if-match extcommunity to remove the configuration.
Syntax
if-match extcommunity ext-comm-list-number&<1-32>
undo if-match extcommunity [ ext-comm-list-number&<1-32> ]
Default
No match criterion is configured.
Views
Routing policy node view
Predefined user roles
network-admin
Parameters
ext-comm-list-number&<1-32>: Specifies an extended community list by its number in the range of 1 to
199. &<1-32> indicates that the argument before it can be entered up to 32 times.
Examples
# Configure node 10 in permit mode for routing policy policy1 to match BGP routes whose extended
community attribute matches extended community lists 100 and 150.
<Sysname> system-view
[Sysname] ip extcommunity-list 100 permit rt 100:100
[Sysname] ip extcommunity-list 150 permit rt 150:150
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy-policy1-10] if-match extcommunity 100 150
Related commands
• apply extcommunity
To Next Page
Loading...
