HP 6125XLG - Reflector Cluster-ID

306
Default
Route reflection between clients is enabled.
Views
BGP IPv4 unicast instance view, BGP-VPN IPv4 unicast instance view, BGP IPv6 unicast instance view
Predefined user roles
network-admin
Usage guidelines
When a route reflector is configured, and the clients of a route reflector are fully meshed, route reflection
is unnecessary because it consumes more bandwidth resources. You can use the undo reflect
between-clients command to disable route reflection instead of modifying network configuration or
changing network topology.
After route reflection is disabled between clients, routes can still be reflected between a client and a
non-client.
Examples
# In BGP IPv4 unicast instance view, disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family unicast
[Sysname-bgp-ipv4] undo reflect between-clients
# In BGP-VPN IPv4 unicast instance view, disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ip vpn-instance vpn1
[Sysname-bgp-vpn1] ipv4-family unicast
[Sysname-bgp-ipv4-vpn1] undo reflect between-clients
# In BGP IPv6 unicast instance view, disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family unicast
[Sysname-bgp-ipv6] undo reflect between-clients
Related commands
• peer reflect-client
• reflector cluster-id
reflector cluster-id
Use reflector cluster-id to configure the cluster ID for a route reflector.
Use undo reflector cluster-id to restore the default.
Syntax
reflector cluster-id { cluster-id | ip-address }
undo reflector cluster-id