126
undo snmp-agent trap enable ospf [ authentication-failure | bad-packet | config-error |
grhelper-status-change | grrestarter-status-change | if-state-change | lsa-maxage | lsa-originate |
lsdb-approaching-overflow | lsdb-overflow | neighbor-state-change | nssatranslator-status-change |
retransmit | virt-authentication-failure | virt-bad-packet | virt-config-error | virt-retransmit |
virtgrhelper-status-change | virtif-state-change | virtneighbor-state-change ] *
Default
OSPF trap sending is enabled.
Views
System view
Predefined user roles
network-admin
Parameters
authentication-failure: Specifies traps about authentication failures on an interface.
bad-packet: Specifies traps about error messages received on an interface.
config-error: Specifies traps about error configuration of an interface.
grhelper-status-change: Specifies traps about GR Helper state change.
grrestarter-status-change: Specifies traps about GR Restarter state change.
if-state-change: Specifies traps about interface state change.
lsa-maxage: Specifies LSA max age traps.
lsa-originate: Specifies traps about locally generated LSAs.
lsdb-approaching-overflow: Specifies traps about approaching LSDB overflows.
lsdb-overflow: Specifies LSDB overflow traps.
neighbor-state-change: Specifies traps about neighbor state change.
nssatranslator-status-change: Specifies traps about NSSA translator state change.
retransmit: Specifies traps about packets that are received and forwarded on an interface.
virt-authentication-failure: Specifies traps about authentication failures on a virtual interface.
virt-bad-packet: Specifies traps about error messages received on a virtual interface.
virt-config-error: Specifies traps about error configuration of a virtual interface.
virt-retransmit: Specifies traps about packets that are received and forwarded on a virtual interface.
virtgrhelper-status-change: Specifies traps about neighbor GR Helper state changes of a virtual
interface.
virtif-state-change: Specifies traps about virtual interface state change.
virtneighbor-state-change: Specifies traps about the neighbor state change of a virtual interface.
Examples
# Enable OSPF to send SNMP traps about authentication failures on an interface.
<Sysname> system-view
[Sysname] snmp-agent trap enable ospf authentication-failure
To Next Page
Loading...
