357
Examples
# Display OSPFv3 information about VLAN-interface 1.
<Sysname> display ospfv3 interface vlan-interface 1
OSPFv3 Process 1 with Router ID 1.1.1.1
Area: 0.0.0.0
-------------------------------------------------------------------------
Vlan-interface1 is up, line protocol is up
Interface ID 65697 Instance ID 0
IPv6 Prefixes
fe80::200:12ff:fe34:1 (Link-Local Address)
2001::1
Cost: 1 State: BDR Type: Broadcast MTU: 1500
Priority: 1
Designated Router: 2.2.2.2
Backup Designated Router: 1.1.1.1
Timers: Hello 10, Dead 40, Wait 40, Retransmit 5, Transmit Delay 1
Neighbor Count is 1, Adjacent neighbor count is 1
Table 79 Command output
Field Descri
Area Area ID that the interface belongs to.
Interface ID Interface ID.
Instance ID Instance ID.
IPv6 Prefixes IPv6 Prefix.
Cost Cost value of the interface.
Type Network type of the interface.
OSPFv3 Process OSPFv3 process.
Area Area ID.
Router ID Router ID.
Network Type Network type of the interface.
MTU MTU value of the interface.
Priority DR priority of the interface.
Designated Router DR on this link.
Backup Designated Router BDR on this link.