70
Predefined user roles
network-admin
network-operator
Parameters
process-id: Specifies an OSPF process by its ID in the range of 1 to 65535.
Usage guidelines
If no OSPF process is specified, this command displays brief information about all OSPF processes.
Examples
# Display OSPF brief information.
<Sysname> display ospf brief
OSPF Process 1 with Router ID 192.168.1.2
OSPF Protocol Information
RouterID: 192.168.1.2 Router Type: NSSA
Route Tag: 0
Multi-VPN-Instance is not enabled
Opaque capable
ISPF is enabled
SPF-schedule-interval: 5 50 200
LSA generation interval: 5
LSA arrival interval: 1000
Transmit pacing: Interval: 20 Count: 3
Default ASE parameters: Metric: 1 Tag: 1 Type: 2
Route Preference: 10
ASE Route Preference: 150
SPF Computation Count: 22
RFC 1583 Compatible
Graceful restart interval: 120
This process is currently bound to MIB
Area Count: 1 Nssa Area Count: 1
ExChange/Loading Neighbors: 0
SNMP trap rate limit interval: 2 Count: 300
Area: 0.0.0.1 (MPLS TE not enabled)
Authtype: None Area flag: NSSA
7/5 translator state: Disabled
7/5 translate stability timer interval: 0
SPF Scheduled Count: 5
ExChange/Loading Neighbors: 0
Interface: 192.168.1.2 (Vlan-interface1)
Cost: 1 State: DR Type: Broadcast MTU: 1500
Priority: 1
Designated Router: 192.168.1.2
Backup Designated Router: 192.168.1.1
To Next Page
Loading...
