HP 6125XLG - Page 95

84
interface-type interface-number: Specifies an interface by its type and number.
neighbor-id: Specifies a neighbor router ID.
Usage guidelines
If no OSPF process is specified, this command displays OSPF neighbor information for all OSPF
processes.
If the verbose keyword is not specified, this command displays brief OSPF neighbor information.
If no interface is specified, this command displays the neighbor information for all interfaces.
If no neighbor ID is specified, this command displays all neighbor information.
Examples
# Display detailed OSPF neighbor information.
<Sysname> display ospf peer verbose
OSPF Process 1 with Router ID 1.1.1.1
Neighbors
Area 0.0.0.0 interface 1.1.1.1(Vlan-interface11)'s neighbors
Router ID: 1.1.1.2 Address: 1.1.1.2 GR State: Normal
State: Full Mode: Nbr is Master Priority: 1
DR: 1.1.1.2 BDR: 1.1.1.1 MTU: 0
Options is 0x02 (-|-|-|-|-|-|E|-)
Dead timer due in 33 sec
Neighbor is up for 02:03:35
Authentication Sequence: [ 0 ]
Neighbor state change count: 6
Table 23 Command output
Field Descri
p
tion
Area areaID interface
IPAddress(InterfaceName)'s neighbors
Neighbor information of the interface in the specified area:
• areaID—Area to which the neighbor belongs.
• IPAddress—Interface IP address.
• InterfaceName—Interface name.
Router ID Neighbor router ID.
Address Neighbor router address.
GR State GR state.