HP 8360 B Series User Manual

Clear Memory
Clear Memory
Function Group
SYSTEM
Menu Map 8
Description
This softkey causes the swept signal generator to return to the
factory preset instrument state, after writing alternating ones and
zeroes over all state information, frequency lists, and save/recall
registers. You can select the number of times to clear memory. When
you select Clear Memory, the swept signal generator displays the
following in the active entry area:
--> # OF TIMES TO CLEAR MEMORY: X
Enter the number of times the state information should be
overwritten. While the swept signal generator is working to overwrite
the state information, it flashes the count on the display.
This softkey causes the swept signal generator to recall the original
calibration data stored in permanent memory (EEROM) all list and
user ALC correction data will be lost.
Programming Codes
SCPI:
SYSTem:SECurity:COUNt <n>
SYSTem:SECurity[:STATe] ON
SYSTem:SECurity[:STATe] OFF
The transition from on to off triggers the blanking. Sending the “off’
message by itself will do nothing.
Analyzer:
SHMZ18HZ
SHKZOHZ
See Also
Security Menu
“Using the Security Features” in Chapter 1
Operating and Programming Reference C-3

HP 8360 B Series Specifications

General

Brand	HP
Model	8360 B Series
Category	Portable Generator
Language	English