Center=Marker
Function Group
MARKER
Menu Map
3
Description
This softkey sets the center frequency of the sweep to the frequency
of the most recently activated marker. Select any marker Ml . . .
MEi,
then select
Center=Marker
to change the center frequency
of the sweep to that of the marker. The frequency span does not
change unless the new sweep limits fall outside the frequency range
of the swept signal generator, in that case the swept signal generator
automatically scales the frequency span to be within the swept signal
generator’s operating frequency range.
Programming Codes
SCPI:
MARKer[n][:FREQuency]
?
FREQuency:CENTer
<freq
from above>[freq suffix]
Analyzer: MC
See Also
C-1
“Marker Operation” in Chapter 1
Clear
Fault
Function Group
Menu Map
Description
Programming Codes
See Also
SERVICE
6
This
softkey
clears all the latched fault status indicators.
SCPI: DIAGnostics:OUTPut:FAULts
The above command relays the fault information and clears all faults.
Analyzer: NONE
Fault Menu
C-2 Operating and Programming Reference
To Next Page
Loading...
Need help?
General
