HP 8360 B Series User Manual

SCPI COMMAND SUMMARY
measured and the absolute value of the peak percent deviation to be
returned.
l MEASure:FM
A query-only command that causes the modulating FM signal level
to be measured and the corresponding peak frequency deviation
returned.
l MODulation:OUTPut:SOURce AMIFM
l MODulation:OUTPut:SOURce?
Sets and queries the source of the rear panel output modulation
BNC.
l MODulation:OUTPut:STATe ONlOFFlllO
l MODulation:OUTPut:STATe?
Sets and queries the state of the rear panel output modulation BNC.
l MODulation:STATe?
Queries the status of any modulation. If any of the modulation states
are on, then it returns a 1, otherwise it returns a 0.
Power Subsystem
Any place where dBm is accepted as a suffix, any level suffix is
accepted also. In the absence of a suffix, the units are assumed to be
as set by the UNIT:POW command.
l POWer:ALC:BANDwidthl:BWIDth <num>[freq
suffixllMAXimumlMINimum
l POWer:ALC:BANDwidth?I:BWIDth? CMAXimumlMINimuml
Sets and queries the ALC bandwidth. This is actually not
continuously variable, so the input is rounded to the nearest possible
switch position.
*RST setting is automatically determined since AUTO
is ON.
l POWer:ALC:BANDwidthl:BWIDth:AUTO ONlOFFlllO
l POWer:ALC:BANDwidthl:BWIDth:AUTO?
Sets and queries the automatic ALC bandwidth selection switch. The
*RST value is ON.
l POWer:ALC:CFACtor <num>[DB] lMAXimumlMINimumlUPlDOWN
l POWer:ALC:CFACtor? CMINimumlMAXimuml
Sets and queries the coupling factor used when the command
POWer:ALC[:SOURce] is set toDIODe or PMETer.
l POWer:ALC:SOURce INTernallDIODelPMETerlMMHead
l POWer:ALC:SOURce?
Operating and Programming Reference S-41

HP 8360 B Series Specifications

General

Brand	HP
Model	8360 B Series
Category	Portable Generator
Language	English