Step Dwell
is active it calibrates the frequency at the end of every frequency
band.
Programming Codes
SCPI:
SWEep:CONTrol:STATe ON]OFF]l]O
SWEep:CONTrol:TYPE
SLAVe
Analyzer:
NONE
See Also
Step Control Master, Step Sap Menu
Step
Dwell
Function Group
Menu Map
Description
Programming Codes
See Also
FREQUENCY
2
This
softkey
lets you set dwell times for points in the stepped
frequency mode of sweep operation. The dwell time for points in step
frequency sweep may range from 100 ps to 3.2 s. The actual time
between points is the sum of dwell and phase lock times.
Select Step Dwell , then use the entry area to enter the desired
value.
SCPI:
SWEep[:FREQ
uency]:DWELl <num>[time suffix] or
MAXimum]
MINimum
Analyzer:
NONE
Step
Sup
Menu,
Sweep Mode Step
Operating and Programming Reference S-67
To Next Page
Loading...
