Sweep
Mode
Ramp
Function Group
Menu Map
Description
Programming Codes
See Also
SWEEP
7
This
softkey
activates the analog frequency sweep mode. Ramp
sweep mode is the factory preset state. An asterisk next to the key
label indicates that this feature is active.
SCPI:
FREQuency:MODE
SWEep
SWEep[:FREQuency]:GENeration ANALog
Analyzer:
NONE
CONNECTORS,
(CONT),
Manual Sweep,
[?iKZJ
“Programming Typical Measurements” in Chapter 1
Sweep
Mode
Step
Function Group
SWEEP
Menu Map
7
Description
This softkey activates the stepped frequency step mode. In this
mode, the swept signal generator steps from the start frequency to
the stop frequency, by the designated frequency step size. Manual,
continuous, and single sweeps can be performed in this mode. An
asterisk next to the key label indicates that this feature is active.
Programming Codes
SCPI:
FREQuency:MODE SWEep
SWEep[:FREQuency]:GENeration
STEPped
Analyzer:
NONE
See Also
I=),
Manual Sweep,
(ml,
Step Sup Menu
“Using Step Sweep” in Chapter 1
S-74 Operating and Programming Reference
To Next Page
Loading...
Need help?
General
