5. Organize the cables (see “Managing cables” on page 139).
6. Verify DC04 SAN Director and port status using the switchShow command.
7. Verify fabric connectivity using the fabricShow command.
Enabling software licenses
Depending on the model purchased, certain licenses are factory installed on the DC04 SAN Director.
To determine which licenses are enabled, use the licenseShow command.
swDir:admin> licenseshow
AAbbccDDeeFFeeGG:
Web license
Zoning license
Extended Fabric license
Fabric Watch license
Performance Monitor license
Trunking license
Security license
In this example, the license key is AAbbccDDeeFFeeGG. Keep a copy of the license key for reference.
The 64-bit chassis ID is required to obtain and activate licenses for the DC04 SAN Director. The
chassis ID is available through the licenseIdShow command. The licenseShow and
licenseIdShow commands must be typed through the active CP blade. Refer to the HP StorageWorks
Fabric OS 6.2.x administrator guide.
Backing up the configuration
Save all key configuration data for the DC04 SAN Director, including license key information, and
upload it to a host for reference. Routine backups of the configuration are recommended to ensure
that the current configuration is available.
After zoning configurations and other changes are complete, back up the configuration by typing
configUpload at the prompt. This command uploads the DC04 SAN Director configuration to the
server so that it is available for downloading to a replacement DC04 SAN Director.
An easy way to back up configuration information is to enable logging on your Telnet session, and
then run the following commands and save the output in a file on a secure host.
• configShow
• ipaddrShow
• licenseShow
• switchShow
Keep copies of key data such as passwords, license keys, and IP addresses in a secure location.
NOTE:
Passwords are not saved in the configuration file, and are not uploaded during a configUpload.
DC04 SAN Director log in and configuration152
To Next Page
Loading...
Need help?
General
