EasyManua.ls Logo

HP A7533A - Brocade 4Gb SAN Switch Base - Back up the Configuration

HP A7533A - Brocade 4Gb SAN Switch Base
256 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Back up the configuration
Save all key configuration data for the DC SAN Director, including license key information, and
upload it to a host for reference. Routine backups of the configuration are recommended to ensure
that the current configuration is available.
After zoning configurations and other changes are complete, back up the configuration by typing
configUpload at the prompt. This command uploads the DC SAN Director configuration to the
server so that it is available for downloading to a replacement DC SAN Director.
An easy way to back up configuration information is to enable logging on your Telnet session, and
then run the following commands and save the output in a file on a secure host.
configShow
ipaddrShow
licenseShow
switchShow
Keep copies of key data such as passwords, license keys, and IP addresses in a secure location.
NOTE:
Passwords are not saved in the configuration file, and are not uploaded during a configUpload.
HP StorageWorks DC and DC04 SAN Backbone Director Switches 55

Table of Contents

Other manuals for HP A7533A - Brocade 4Gb SAN Switch Base

Related product manuals