Output from supportshow command
Location of spptshow.txt file:
Notes regarding supportshow output:
Information about the new chassis
New Factory Serial Num:
New Serial Num (if available):
To record critical DC04 SAN Director and SAN information:
1. Open a Telnet session and log in to the DC04 SAN Director as admin. The default password is
password. Enable the logging function on your Telnet or serial console connection.
2. Back up the current configuration.
Type configUpload, then enter the requested information at the prompts.
This command uploads the DC04 SAN Director configuration to the customer-defined FTP server,
making it available for downloading. For more information about this command, refer to the
Fabric OS Command Reference.
rsl8-st03-dcx-1:admin> configupload
Protocol (scp or ftp) [ftp]: ftp
Server Name or IP Address [host]: 123.123.123.123
User Name [user]: Admin24
File Name [config.txt]: config-switch0.txt
Password:
Upload complete
rsl8-st03-dcx-1:admin>
HP StorageWorks DC and DC04 SAN Backbone Director Switches 195
To Next Page
Loading...
Need help?
General
