1. Log in to the DC04 SAN Director as admin:
rsl8-st03-dcx-1:admin> login
login: admin
password: xxxxxxxx
rsl8-st03-dcx-1:admin>
2. Type slotShow command and verify that all the installed cards are detected and that their status
is operational (enabled).
rsl8-st03-dcx-1:admin> slotShow
Slot Blade Type ID Status
---------------------------------
1 UNKNOWN VACANT
2 SW BLADE 55 ENABLED
3 CORE BLADE 52 ENABLED
4 CP BLADE 50 ENABLED
5 CP BLADE 50 ENABLED
6 CORE BLADE 52 ENABLED
7 UNKNOWN VACANT
8 SW BLADE 55 ENABLED
rsl8-st03-dcx-1:admin>
3. Verify that the DC04 SAN Director is functioning correctly by typing switchShow or
switchStatusShow.
This switchShow command displays DC04 SAN Director and port status information.
rsl8-st03-dcx-1:admin> switchshow
switchName: rsl8-st03-dcx-1
switchType: 62.1
switchState: Online
switchMode: Native
switchRole: Subordinate
switchDomain: 11
switchId: fffc0b
switchWwn: 10:00:00:05:1e:39:59:67
zoning: OFF
switchBeacon: OFF
blade3 Beacon: OFF
blade5 Beacon: OFF
blade8 Beacon: OFF
blade10Beacon: OFF
Index Slot PortAddressMediaSpeedStateProto
===========================================================
32 3 00b2000idN4OnlineL-Port 5 public
33 3 10b2100__N8No_Module
34 3 20b2200__N8No_Module
35 3 30b2300__N8No_Module
36 3 40b2400idN4OnlineF-Port
10:00:00:00:c9:51:00:2d
37 3 50b2500__N8No_Module
rsl8-st03-dcx-1:admin>
Replacing DC04 SAN Director field-replaceable units (FRUs)202
To Next Page
Loading...
Need help?
General
