Load paper to Tray 2
Introduction
CAUTION: Do not extend more than one paper tray at a time. Do not use paper tray as a step. Keep hands out
of paper trays when closing. All trays must be closed when moving the printer.
The following information describes how to load paper into Tray 2 and the optional 550-sheet trays. These trays
hold up to 550 sheets of 75 g/m
2
(20 lb) paper.
NOTE: The procedure to load paper for all 550-sheet trays is the same as for Tray 2. Only Tray 2 is shown here.
1. Open the tray.
NOTE: Do not open this tray while it is in use.
2. Adjust the paper-length and paper-width guides by
squeezing the blue adjustment latches and sliding
the guides to the size of the paper being used.
ENWW Load paper to Tray 2 25
To Next Page
Loading...