239
Step Command Remarks
3. Enable BGP route refresh for
a peer or peer group.
• Enable BGP route refresh for
the specified peer or peer
group:
peer { group-name |
ip-address [ mask-length ] }
capability-advertise
route-refresh
• Enable BGP route refresh
and multi-protocol extension
capability for the specified
peer or peer group:
undo peer { group-name |
ip-address [ mask-length ] }
capability-advertise
conventional
By default, BGP route refresh and
multi-protocol extension capability
are enabled.
4. Return to user view.
return
N/A
5. Perform manual soft-reset.
refresh bgp
{ ip-address
[ mask-length ] |
all
|
external
|
group
group-name
|
internal
}
{
export
|
import
}
ipv4
[
unicast
]
[
vpn-instance
vpn-instance-name ]
N/A
To configure manual soft-reset (IPv6):
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance
view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Enable BGP route refresh for
a peer or peer group.
• Enable BGP route refresh for
the specified peer or peer
group:
peer { group-name |
ipv6-address
[ prefix-length ] }
capability-advertise
route-refresh
• Enable BGP route refresh
and multi-protocol extension
capability for the specified
peer or peer group:
undo peer { group-name |
ipv6-address
[ prefix-length ] }
capability-advertise
conventional
By default, BGP route refresh and
multi-protocol extension capability
are enabled.
4. Return to user view.
return
N/A
To Next Page
Loading...
