HPE FlexNetwork 5510 HI Series

238
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance
view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Enter BGP IPv4 unicast
address family view or
BGP-VPN IPv4 unicast
address family view.
address-family ipv4
[
unicast
] N/A
4. Save all route updates from
the peer or peer group.
peer
{ group-name | ip-address
[ mask-length ] }
keep-all-routes
By default, the routes are not
saved.
This command takes effect only
for the routes received after this
command is executed.
To save all route updates from the specified peer or peer group (IPv6):
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view
bgp
as-number N/A
3. Enter BGP IPv6 unicast
address family view.
address-family ipv6
[
unicast
] N/A
4. Save all route updates from
the peer or peer group.
peer
{ group-name | ipv6-address
[ prefix-length ] }
keep-all-routes
By default, the routes are not
saved.
This command takes effect only
for the routes received after this
command is executed.
Configuring manual soft-reset
To configure manual soft-reset (IPv4):
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance
view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A