147
Authentication Mode is Auto
Port Control Type is Mac-based
802.1X Multicast-trigger is enabled
Mandatory authentication domain: NOT configured
Guest VLAN: NOT configured
Auth-Fail VLAN: NOT configured
Critical VLAN: NOT configured
Critical recovery-action: NOT configured
Max number of on-line users is 256
EAPOL Packet: Tx 16331, Rx 102
Sent EAP Request/Identity Packets : 16316
EAP Request/Challenge Packets: 6
EAP Success Packets: 4, Fail Packets: 5
Received EAPOL Start Packets : 6
EAPOL LogOff Packets: 2
EAP Response/Identity Packets : 80
EAP Response/Challenge Packets: 6
Error Packets: 0
1. Authenticated user : MAC address: 0002-0000-0011
Controlled User(s) amount to 1
As NTK is enabled, frames with an unknown destination MAC address, multicast address, or
broadcast address will be discarded.
Troubleshooting port security
Cannot set the port security mode
Symptom
Cannot set the port security mode.
[Device-Ethernet1/1] port-security port-mode autolearn
Error:When we change port-mode, we should first change it to noRestrictions, then change
it to the other.
Analysis
For ports operating in a port security mode other than noRestrictions, you cannot change the port
security mode directly using the port-security port-mode command.
Solution
Set the port security mode to noRestrictions first.
[Device-Ethernet1/1] undo port-security port-mode
[Device-Ethernet1/1] port-security port-mode autolearn
Cannot configure secure MAC addresses
Symptom
Cannot configure secure MAC addresses.
To Next Page
Loading...
Need help?
General
