HPE FlexNetwork MSR Series Comware 5 Security Configuration Guide

366
Figure 118 Specifying the host name (or IP address)
c. Click Open to connect to the server.
If the connection is successfully established, the system asks you to enter the username
and password. After entering the username (client001) and password (aabbcc), you can
enter the CLI of the server.
Publickey authentication enabled Stelnet server
configuration example
Network requirements
As shown in Figure 119, you can log in to the router through the Stelnet client (SSH2) that runs on the
host. The router acts as the Stelnet server, adopting publickey authentication and the RSA public key
algorithm.
Figure 119 Network diagram
Configuration considerations
In the server configuration, the client public key is required. Use the client software to generate the
RSA key pair on the client before configuring the Stelnet server.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English