375
# Transmit the public key file to the server through FTP or TFTP. (Details not shown.)
2. Configure the Stelnet server:
# Generate the RSA key pairs.
<RouterB> system-view
[RouterB] public-key local create rsa
The range of public key size is (512 ~ 2048).
NOTES: If the key modulus is greater than 512,
It will take a few minutes.
Press CTRL+C to abort.
Input the bits of the modulus[default = 1024]:
Generating Keys...
++++++++
++++++++++++++
+++++
++++++++
# Generate a DSA key pair.
[RouterB] public-key local create dsa
The range of public key size is (512 ~ 2048).
NOTES: If the key modulus is greater than 512,
It will take a few minutes.
Press CTRL+C to abort.
Input the bits of the modulus[default = 1024]:
Generating Keys...
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+++++++++++++++++++++++++++++++++++
# Enable SSH server function.
[RouterB] ssh server enable
# Configure an IP address for interface Ethernet 1/1. The Stelnet client uses this address as the
destination address of the SSH connection.
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] ip address 192.168.1.40 255.255.255.0
[RouterB-Ethernet1/1] quit
# Set the authentication mode for the user interfaces to AAA.
[RouterB] user-interface vty 0 4
[RouterB-ui-vty0-4] authentication-mode scheme
# Enable the user interfaces to support SSH.
[RouterB-ui-vty0-4] protocol inbound ssh
# Set the user command privilege level to 3.
[RouterB-ui-vty0-4] user privilege level 3
[RouterB-ui-vty0-4] quit
# Import the peer public key from the file key.pub, and name it ClientKey.
[RouterB] public-key peer ClientKey import sshkey key.pub
# Create an SSH user client002 with the authentication method publickey, and assign the
public key ClientKey to the user.
[RouterB] ssh user client002 service-type stelnet authentication-type publickey
assign publickey ClientKey
3. Establish a connection to the Stelnet server:
# Establish an SSH connection to the Stelnet server 192.168.1.40.
To Next Page
Loading...
Need help?
General
