Removing a blank lock insert
To remove a blank lock insert, use the blank lock installation handle to turn the
locking screw counterclockwise until you can lift the blank lock insert out of the lock
cylinder.
Note: See “Installing and removing lock inserts” on page 82 to install any lock
inserts or blank lock inserts in your I/O devices.
Installing the keyboard-V and the PLU keyboard
When you install a keyboard-V or the PLU keyboard, you can perform any of these
tasks:
v Change the keytop label
v Change the keyboard layout
v Change the keytops
Changing the keytop labels
To change the keytop labels, follow these procedures:
1. Insert the keytop remover A in Figure 87 into a key B and remove the
keycap.
2. Place the label C on the keytop.
3. Install the transparent keycap on the keytop.
Note:
The USB keyboard-V and the PLU keyboard are not shipped with
transparent keycaps; they are shipped with solid keycaps.
A
B
C
Figure 87. Installing the keytop labels
Updated October 31, 2007
Chapter 4. Installing external options 85
To Next Page
Loading...
Need help?
General
