IBM 4800-741 - Saving the Battery Date Label; Inserting the UPS

f. Push the battery back into the UPS, close and tighten the screws holding
the door (Picture 4).
g. Peel off the battery date label (1 in Figure 20) and place it on the inside of
the front cover assembly (2 in Figure 20).
6. Insert the power supply into the housing as shown in Figure 21.
1
2
Figure 20. Saving the battery date label
Figure 21. Inserting the UPS
Updated October 31, 2007
Chapter 2. Installation and system setup 31