Adjusting The End Of Forms Distance
380
17. Press ENTER. The number of dots will move up to the top line of the display.
18. Using the SCROLL↑ or SCROLL↓ key, adjust the
XX
DOTS value up or down by the number of dots you counted in step
12. (If the comb pattern stopped short of the perforation, increase the number of dots. If the comb pattern printed beyond
the perforation, decrease the number of dots.)
19. Press ENTER to select the new number of dots as the active value. (The asterisk that appears tells you that it is now the
active value.)
20. Press STOP to put the printer into NOT READY mode.
21. Run the END OF FORMS ADJUST and the END OF FORMS ADJUSTMENT VALUE tests until the comb pattern prints at
an acceptable distance from the page perforation. (Return to step 7.)
22. When the End of Forms Adjustment is acceptable, reload the paper, feed it past any remaining unused holes that you tore
in it, and set the top of form.
23. Press RETURN + ENTER to lock the ENTER key.
24. Press START to put the printer into READY mode.
To Next Page
Loading...
Need help?
General
