Chapter 1 Troubleshooting Display Messages
44
001 END OF FORMS
LOAD FORMS (continued)
11. Power on the printer in download mode and load flash memory
(page 238).
a. If you encounter loading problems, go to the appropriate error
code for resolution.
b. If you encounter the failure or message that brought you to
this procedure, replace the controller board (page 319). After
replacing the controller board, DO NOT make the printer
READY, but proceed immediately to the next step.
12. Download and install the latest code from IBM First (page 231).
13. Power on the printer in download mode and load flash memory
(page 238).
14. If you encounter the failure after replacing the controller board,
reinstall the original controller board and contact your DDS and
Second Level Support.
Table 3. Message List
Operator Panel Message Explanation Corrective Action
To Next Page
Loading...
Need help?
General
