Display Messages
47
006 HOST SYSTEM
REQUEST ATTENTION
Host attention message: the host
computer or printer controller
requires attention.
Not a printer problem.
007 FM HEADER ERROR
Applications software has violated
header format parameters.
Not a printer problem. Have the system administrator correct
applications data or configuration.
008 HOLD PRINT TIMEOUT
PRESS START
Status message: the printer was
offline more than 10 minutes and
the “Intervention Required”
parameter is set to “Send to Host.”
Press START to put the printer in the READY state.
009 INVALID KEY PRESS
Attention message informing the
operator that the wrong key was
pressed.
No action required.
010 PARAMETER ERROR
The printer received an illegal
parameter value in the command
code.
1. Press STOP to clear the fault. Press START to go to the READY
state.
2. Run the print job that generated the error message. If the
message appears, check the host data for invalid characters.
3. Ask the system operator to verify that the printer’s Device ID is set
to the correct emulation with respect to the host configuration.
4. Run the print job that generated the error message. If the
message appears, go to Communications Failures, page 211.
011 SCS COMMAND ERROR
The printer received an undefined
control character (hex 40) through
the coax/twinax interface.
1. The printer clears the error.
2. Run the print job that generated the error message. If the
message appears, verify that there are no invalid control codes in
the host data.
3. Ask the system operator to verify that the printer’s Device ID is set
to the correct emulation with respect to the host configuration.
4. Run the print job that generated the error message. If the
message appears, go to Communications Failures, page 211.
Table 3. Message List
Operator Panel Message Explanation Corrective Action
To Next Page
Loading...
Need help?
General
