IBM V7000 User Manual

152 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
6. Use the Task Launch Dialog box that is opened to verify the name of the inventory, and
time for running it, as shown in Figure 3-95.
Figure 3-95 Task Launch Dialog
You can use Storage Control to monitor the health of storage subsystems, storage pools,
storage volumes, and fabric switches.
Run the inventory against the Storage Control farm to see updated health status. Follow
these steps to retrieve the health and alert status for the devices managed by Storage
Control.
1. Select Resource Explorer  All Systems. Select the managed device for which you
want to get the latest health and alert status.
2. Discover and then unlock the device.
3. Select the farm that covers the selected device and collect inventory against it.
4. For DS3000, DS4000, and DS5000 TPC devices only: Under the farm, right-click the
DSnnnn device, and select Collect inventory.
5. You will now receive TPC alerts for devices under the farm.
Tip: At this point, you will receive TPC alerts from the farm, but you will not yet receive
alerts specific to any devices under this farm.
Important: You must repeat this step each time you want to check for an event on these
devices.

IBM V7000 Specifications

General

Model	IBM Storwize V7000
Storage Type	Hybrid Flash Array
Maximum Capacity	1.2PB
RAID Levels	0, 1, 5, 6, 10
Connectivity	8 Gbps Fibre Channel, 16 Gbps Fibre Channel, 1 Gbps iSCSI, 10 Gbps iSCSI
Management	Command-line interface (CLI), Graphical user interface (GUI)
Form Factor	2U
Drive Bays	12
Maximum Raw Capacity	1.2PB
Operating System Support	AIX, HP-UX, Linux, VMware, Windows
Data Reduction Features	Real-time Compression, Deduplication
Drive Types	SSD, HDD
Scalability	Scale-up (drive enclosures) and scale-out (clustering) capabilities