274 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
2. Click Fibre Channel Host. The Wizard automatically moves to the next panel.
Figure 6-24 shows that the first choice to make is whether you are creating a Fibre
Channel attached host or an iSCSI host.
Figure 6-24 New Host creation - select iSCSI or FC host
3. After choosing the host type, give the host a name.
4. Select the World Wide Names (WWNs) that represent the Host Bus Adaptor (HBA) ports
in your server. If they do not display on the list, click Rescan. If they still do not display,
check your SAN-switch Zoning.
Figure 6-25 shows that we are selecting the two WWNs that represent the two HBAs in
our server.
Figure 6-25 New Host creation - select between available World Wide Names
To Next Page
Loading...
