296 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
5. Configure the host that needs to access the data after the migration, or create new hosts
as needed in Step 5, and click Next (Figure 7-14).
Figure 7-14 Storage Migration Wizard step 5 - Configure Hosts
Before you configure any hosts, make sure that the appropriate drivers have been
installed on the host and that the host zones have been configured correctly.
If the host that needs to access the data on the volume after the migration is complete is in
the list, select the host and click Next.
If the host has not been created on the IBM Flex System V7000 Storage Node storage
system, click New Host to define a host and follow the on-screen instructions to create
new host. In our example, we assume that IBM Flex System V7000 Storage Node already
has been configured with the correct host and corresponding World Wide Names or iSCSI
addresses. After the host has been created, you can find it in the host list.
To Next Page
Loading...
