386 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
If you chose the clone or backup preset at the beginning of this wizard, Create a
generic volume is your default choice (Figure 9-23).
Figure 9-23 The default choice when creating a FlashCopy mapping
f. Click Finish when you make your decision, and the FlashCopy mapping is created on
your volume with a new target (Figure 9-24). The status of the newly created
FlashCopy mapping is Idle; it could be started, as described in “Starting a FlashCopy
mapping” on page 389.
Figure 9-24 New FlashCopy mapping has been created with a new target
To Next Page
Loading...
