546 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
3. Highlight the iSCSI Software Initiator and click Properties. The iSCSI initiator properties
window opens. Select the Dynamic Discovery tab (Figure 12-51) and click Add.
Figure 12-51 iSCSI Initiator properties
4. To add a target, enter the target IP address (Figure 12-52). The target IP address is the IP
address of a node in the I/O group from which you are mapping the iSCSI volume. Leave
the IP port number at the default value of 3260, and click OK. The connection between the
initiator and target is established.
Figure 12-52 Enter a target IP address
Repeat this step for each IBM Flex System V7000 Storage Node iSCSI port you want to
use for iSCSI connections.
iSCSI IP addresses: The iSCSI IP addresses are different for the cluster and canister
IP addresses; they have been configured in 6.2.2, “Creating an iSCSI attached host” on
page 276.
To Next Page
Loading...
