Chapter 13. Maintenance and troubleshooting 619
Follow this procedure to configure the Call Home event notification function:
1. If the step to configure Support Notifications (Step 5 of 7) was complete already during
initial setup, as shown in Figure 13-43 and Figure 13-44, besides sending a test email to
check that all connections and infrastructure are set up correctly, no further Call Home
configuration is required.
Figure 13-43 Configure email event notification during initial setup
2. To enable the Call Home event notification function, go to IBM Flex System V7000 Storage
Node management GUI Settings Event Notifications Email Enable Email
Event Notification, as shown in Figure 13-44.
Figure 13-44 Enable email event notification after the initial setup is complete
To Next Page
Loading...
