IBM V7000 User Manual

Appendix A. CLI setup and configuration 637
2. From the Category pane on the left side of the PuTTY Configuration window, click
Connection  SSH to open the PuTTY SSH Configuration window (Figure A-11).
Figure A-11 SSH protocol version 2
3. In the right pane, in the “Preferred SSH protocol version” section, select 2.
4. From the Category pane on the left side of the PuTTY Configuration window, click
Connection  SSH  Auth. As shown in Figure A-12, in the right pane, in the “Private
key file for authentication:” field under the Authentication Parameters section, either
browse to or type the fully qualified directory path and file name of the SSH client private
key file created earlier (for example, C:\Support Utils\PuTTY\icat.PPK).
Figure A-12 SSH authentication
5. From the Category pane on the left side of the PuTTY Configuration window, click
Session to return to the Session view (Figure A-10 on page 636).

IBM V7000 Specifications

General

Model	IBM Storwize V7000
Storage Type	Hybrid Flash Array
Maximum Capacity	1.2PB
RAID Levels	0, 1, 5, 6, 10
Connectivity	8 Gbps Fibre Channel, 16 Gbps Fibre Channel, 1 Gbps iSCSI, 10 Gbps iSCSI
Management	Command-line interface (CLI), Graphical user interface (GUI)
Form Factor	2U
Drive Bays	12
Maximum Raw Capacity	1.2PB
Operating System Support	AIX, HP-UX, Linux, VMware, Windows
Data Reduction Features	Real-time Compression, Deduplication
Drive Types	SSD, HDD
Scalability	Scale-up (drive enclosures) and scale-out (clustering) capabilities