EasyManuals Logo

IDEC MICRO/I HG1P-ST32 Series User Manual

IDEC MICRO/I HG1P-ST32 Series
1665 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1061 background imageLoading...
Page #1061 background image
WindO/I-NV4 Users Manual 17-5
2 Preventive Maintenance Function Configuration Procedure
17
Preventive Maintenance Function
6 Select the Measure Operation Time check box on the Operation Time tab.
If you are not counting the operation time, leave the Measure Operation Time check box cleared and proceed to
step
9.
7 Specify the destination device address for the counted operation time.
You can only specify an HMI Keep Register (LKR).
Click to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2 “5.1 Device
Address Settings” on page 2-68.
8 Select the data type for the value of Measure Operation Time device address with Data Type.
This concludes configuring operation time counting.
9 Click the Operation Count tab.
10
Select the Measure Operation Count check box.
If you are not counting the operation count, leave the Measure Operation Count check box cleared and proceed to
step
13
.
11
Specify the destination device address for the counted operation count.
You can only specify an HMI Keep Register (LKR).
Click to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2 “5.1 Device
Address Settings” on page 2-68.
12
Select the data type for the value of Measure Operation Count device address with Data Type.
This concludes configuring operation count counting.
13
Click OK to close the Individual Settings dialog box.
You are returned to the Preventive Maintenance Settings dialog box.
14
Repeat steps 2 to
13
to register settings to count the operation time and operation count in all the used numbers.
This concludes configuring operation time and operation count counting.
Next, configure the functions to execute using counted data.
“4.1 Displaying the Counted Operation Count on a Numerical Display” on page 17-11
“4.2 Notifying with a Beep when the Counted Operation Time Reaches the Threshold” on page 17-14

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IDEC MICRO/I HG1P-ST32 Series and is the answer not in the manual?

IDEC MICRO/I HG1P-ST32 Series Specifications

General IconGeneral
BrandIDEC
ModelMICRO/I HG1P-ST32 Series
CategoryControl Panel
LanguageEnglish

Related product manuals