3 Security Dialog Box
23-44 WindO/I-NV4 User’s Manual
● Options Tab
■ Use Password to open a Project
Select this check box and enter a password to protect the project with a dedicated password when opening it.
The number for the password is 4 to 15 characters. Only uppercase alphabetic characters and numbers can be used.
The operations subject to password protection are as follows.
• Opening projects
• Reusing screens
• Opening projects after uploading project data
■ Change User by Device Address
Select this check box to switch the user account according to the value of device address.
The user account is specified by using the number on the General tab.
Example: When the trigger device address is D0 and the default user is selected as User1
The user account switches according to the value of device address.
Confirm Password: Re-enter the password that was entered in Use Password to open Project.
Write down the password so you do not forget it and save that note in a safe place.
(Trigger Device Address): Specifies the word device to write the number.
Click to display the Tag Editor. For the device address configuration procedure, refer to
Chapter 2 “5.1 Device Address Settings” on page 2-68.
123
No.
User Name
User3
User2User1
(Default user)
0
User account
Trigger device address
D0 value
Switch to default
user account
1
Switch to user
account no. 1
2
Switch to user
account no. 2
3
Switch to user
account no. 3
4
None
Action
User3 User3
User2User1 User1
The user account is not switched when the value of
device address is a number not configured to a user
account or an invalid number.
If the value of device address is
0, the user is switched to the
default user.
To Next Page
Loading...
Need help?
General
