IDEC MICRO/I HG1P-ST32 Series User Manual

WindO/I-NV4 User’s Manual 29-3
1 Project Transfer Function
29
Data Transfer Function
1.3 Converting Project for Transfer
Project must be converted to dedicated data for transfer in order to download project to the MICRO/I using the
project transfer function.
Use the following procedure to create project data for transfer using an external memory device
*1
.
1 Insert an external memory device
*1
in the computer.
When using an SD memory card, insert it into the computer's memory card slot or via a memory card reader/writer.
When using a USB flash drive, insert the USB flash drive in the computer’s USB port.
2 Open the project to transfer using WindO/I-NV4.
3 On the Home tab, in the Project group, click the Download icon.
The Download dialog box is displayed.
*1 Only USB flash drive for HG2G-5T and HG1G/1P
The Project Transfer function supports the project which name is used alphanumeric characters only.
Computer
Through an external
memory card reader/writer
SD memory card
USB flash drive
SD memory card
To USB port
To SD memory card slot
To use the Project Transfer function, select the project which name is used alphanumeric characters only.
When the project has not been saved after it was opened, a save confirmation message is displayed.
Click the OK button to save the project and display the Download dialog box.
Click on the Cancel button to return to the editing screen without saving the project.

IDEC MICRO/I HG1P-ST32 Series Specifications

General

Brand	IDEC
Model	MICRO/I HG1P-ST32 Series
Category	Control Panel
Language	English