Inovance IS810N-INT Series - 1.2 Acceptance Precautions; 1.3 Storage and Transportation Precautions; 1.4 Installation Precautions

IS810N-INT Series Servo System User Manual (Brief) Chapter 1 Safety Information and Precautions
- 10 -
1.2 Acceptance Precautions
Item Description
Whether the delivered product is
consistent with your order
The box contains the equipment and the IS810N user
guide. Verify the model according to the servo motor
and servo drive nameplates.
Whether the product is damaged Check the overall appearance of the product. If there is
anything missing or damaged, contact Inovance or your
supplier immediately.
Whether the rotating shaft of the
servo motor rotates smoothly
Normally, the shaft of the servo motor can be rotated
manually, unless it is congured with a brake.
1.3 Storage and Transportation Precautions
CAUTION
CAUTION
u
Do not store or lay the equipment in the following environment conditions. Failure to comply
will result in a re, electric shock or equipment damage.
u
Direct sunlight; Ambient temperature exceeding the required condition; Relative humidity
exceeding the required condition Large temperature uctuation and condensation Close to
corrosive and combustible gas Heavy dust, dirt, salt, and metal powder Water, oil, and drug
drop Vibration and impact transmitted to main body Do not move the equipment by holding
the cables or motor shaft. Failure to comply may result in personal injuries or equipment
damages.
u
Do not stack drives. Failure to comply may result in personal injuries or equipment
damages.
1.4 Installation Precautions
CAUTION
CAUTION
u
Do not install the drive in an environment with water or corrosive gas.
u
Do not subject the drive to combustibles. Failure to comply may result in an electric shock
or a re.
u
Do not sit on the drive or put heavy objects on it. Failure to comply may result in personal
injuries.
u
Install the drive inside a cabinet with re and electric protection. Failure to comply may
result in a re.
u
Ensure good ventilation and prevent entry of foreign objects. Otherwise, aging of internal
components may accelerate, causing a fault or re.
u
Install the drive in the required direction. Failure to comply may result in faults.
u
Ensure that there is specied gap between the drive, cabinet internal surface, and other
devices. Failure to comply will result in a re or fault.
u
Do not put much weight onto the product. Failure to comply may result in faults.